Create and Apply the Enrichment - Fluid Topics - 3.4 - Technical Notes

Enrich and Clean Metadata

Fluid Topics
Fluid Topics Version
Technical Notes
Target Audience

Once a vocabulary is published, the next step is to access the Enrich and Clean administration interface and configure a new rule.

Attention: The New rule button is disabled if no vocabulary has been defined.
  1. In Administration > Knowledge Hub > Enrich and Clean, select New Rule.

    The New rule button allows administrators to apply a vocabulary created in the Back Office

    The following window is displayed:

    The New rule window allows administrators to set the metadata enrichment
  2. Set the new rule as follows:
    • Select the metadata subclass on which to apply the new rule.

      The metadata element to enrich is selected
    • Select the vocabulary to use to enrich the previously selected metadata.

      The vocabulary to apply is selected
    • Enter a name for the newly generated metadata.
      Note: If no name is entered here, the new metadata is named $metadata_custom, e.g., subclass_custom.
    • Tick Apply hierarchy to set the newly generated metadata as a hierarchical facet..
    • Leave Remove unclassified values unchecked.
  3. Select the Create button.

    The new rule is ready for use in the Enrich and Clean interface.

    The Enrichment table gathers the vocabulary to apply and the metadata to enrich
  4. Select Save and Apply.
    Note: Saving and applying modifications results in a reprocessing of all content. Reprocessing content can take a long time, during which new publications are put on hold.