FluidTopicsControlFile.xml Control File - Fluid Topics - 3.6

Upload DITA Content to Fluid Topics

Product
Fluid Topics
FT_Version
3.6
Category
Technical Notes

When uploading an archive containing DITA content to Fluid Topics, an additional control file can be added to the archive.

From Fluid Topics v3.4.55, the FluidTopicsControlFile.xml control file replaces the FluidTopicsDitaControlFile.xml.
Note: If both the FluidTopicsControlFile.xml and the FluidTopicsDitaControlFile.xml are found in a same archive, only the FluidTopicsControlFile.xml is taken into account. It raises the following error in the Back Office: An other control file in the legacy format has been found in this archive (FluidTopicsDitaControlFile.xml), it will be ignored
Its content depends on the action you wish to perform:
Note: When successfully uploading a control file (FluidTopicsControlFile.xml or FluidTopicsDitaControlFile.xml) through a source that is not of the Unstructured Documents type, no feedback is provided in the History table of the Knowledge Hub interface. However, even though Success=0, Failed=0 and Rejected files=0 mean that the upload was successful.
No failed or rejected file means that the upload was successful
More information about the upload can be consulted in the Dataflow interface of the Back Office.
Note: An inheritance principle applies to attributes in control files.